|   | | 1. Position the equipment for fastening. 2. For 2-corner attachment, put a buckle set (two buckles on a strap) at diagonal corners of the equipment. For 4-corner attachment (2 kits), put buckle sets at each corner of the equipment. 3. Clean the holding surface and the sides of the equipment where the fasteners will be attached with the alcohol pads provided. Let dry or wipe dry with a clean cloth or paper towel. Surfaces must be clean and dry. 4. Position a fastening set for attachment. The strap should be in line with the edge of the equipment. Open the top buckle and adjust the strap for the minimum distance needed between the two fastening buckles for attachment (Fig. C). Lock the buckle in place. Note: If the strap is the same for each buckle set, adjust the first set (Step 4) and use it to adjust the strap length of the others. Excess strapping can be cut off with scissors. This should be done after the buckle sets have been adjusted for strap length. Leave 1/2" of strap at the end of each buckle for ease in releasing and refastening equipment. 5. Remove the paper from the adhesive pad, and attach the lower fastener first to the holding surface where previously positioned at the base of the equipment. Press down firmly on the buckle with a slight twisting motion. 6. Remove the adhesive paper on the remaining buckle, and attach it where previously positioned on the side of the equipment, using the strap for alignment with the buckle below it. Press down firmly on the buckle with a slight twisting motion. Continued on the next page... | |
