Thumb Lock^® Attachment (cont.)

7. Repeat steps 4 and 5 for the remaining buckle sets. 8. IMPORTANT: Unlock the buckle of each fastener for the first 4 hours of bonding. After 4 hours, snug up the straps and re-lock the buckles. The straps should be tight but not pulling.

To Release: Unlock the equipment buckles and lift off the equipment. To re-fasten, position the equipment over the fasteners, reinsert the straps through the buckles, and lock.

Fastening Monitors: It is recommended to attach the fasteners directly to the monitor, not the pedestal. Some pedestals are not strong enough to support top-heavy monitors and will snap loose in heavy movement.

Stacked Equipment: Stacked equipment can be secured by adding a third buckle to each buckle set. When adding a third buckle, ensure the hinges of the two upper buckles face downward (see Feg. D). Extra length strap is available in kits or rolls.

Call 805-551-1446 for product info.

Removal and Relocation of Fasteners: Thumb Lock adhesive is non-hardening, and the fasteners can be remove without damaging the surface they're attached to.

The adhesive is NOT reusable and must be replaced to reuse the fastener. Removal kits are available.